MTD TLP 2824-Z - Manual (Page 23)

Getting Started
Loading Ribbon
980533-001 A TLP 2824-Z User Guide 23
Attach and Tighten the Ribbon
You must align the ribbon so that it will be taken straight onto the core.
1. Attach the ribbon to the take up core. Use the adhesive strip on new rolls; otherwise, use
tape.
2. Turn the ribbon take-up gear counter-clockwise (top moves toward rear) to remove slack
from the ribbon.
3. Close the top cover. Remember that you need to release the cover lock, lower the top
cover, and press down until the latches snap into place.