Thermal-transfer tlp model – MTD TLP 2824-Z User Manual
Page 44
Advertising
44
TLP 2824-Z User Guide
980533-001 A
Maintenance
Replacing the Print Head
Thermal-Transfer TLP Model
Before following the steps in this procedure, open the printer by pulling the release latches
forward then lifting the top cover. Remove any ribbon from the carriage.
Removal
1.
Grasp the print head spring and pull it to the left; then, slide it free of the carriage.
2.
Use the spring to pry the print head clip off the right side of the carriage.
3.
Pull the print head and bracket forward.
4.
Use a #2 Phillips driver to remove the screw that holds the ground wire.
5.
Unplug both bundles of print head wires from their connectors.
Advertising