Zebranet® printserver ii for ethernet networks – MTD TLP 2824-Z User Manual
Page 59
Advertising
Interfaces
ZebraNet® PrintServer II for Ethernet Networks
980533-001 A
TLP 2824-Z User Guide
59
ZebraNet® PrintServer II for Ethernet Networks
This interface uses an RJ-45 straight-through cable type. The table below provides the pinout
assignments.
The figure above has the perspective looking into the printer RJ-45 modular connector.
You can refer to the ZebraNet® PrintServer IITM for Ethernet Networks Installation and
Operation Guide for details regarding this interface.
The RJ-11 jack on Ethernet boards is used for factory tests only.
Signal
Pin
Pin
Signal
Tx+
1
1
Tx+
Tx-
2
2
Tx-
Rx+
3
3
Rx+
---
4
4
---
---
5
5
---
Rx-
6
6
Rx-
---
7
7
---
---
8
8
---
Advertising