Micon IP-220E - Manual (Page 14)

13
Chapter 4: iGuardware
password. To reset the iGuard account password, you will need to re-install the
firmware using iGuard Utility.
8. Click “Next >” to upload these configuration to iGuard.
Fig.9 iGuard PPPoE Setup
9. Click “Next >” to save and restart iGuard with the new configurations.
4.2.1.2 Launch iGuard
Once you have finished with the above Setup Wizard, either click “Launch iGuard” or
double click on the iGuard listed on the table, You will be bring to the iGuard Web