Micon IP-220E - Manual (Page 7)

6
Chapter 3: Hardware Installation
Chapter 3 Hardware Installation
Before you start using the iGuard IP-220E network camera, you will need to set-up
both the hardware and software. The following is a flow chart on the installation
procedure:
Connect network cable, and power
Adapter
To iGuard IP-220E
Connect Network cable to ROUTER
/ DSL or Cable modem
Setup iGuard Web Manager
(Chapter 4) and iGuard-Viewer
(Chapter5) (Otional)
Router Programming (Appendix).
iGuard set-up completed
1
2
3
4
5