MK Diamond Products MK-370EXP - Manual (Page 11)

11
SAFETY LABEL LOCATIONS
Safety labels contain important safety information. Please read the information contained on each safety label.
These labels are considered a permanent part of your saw. If a label comes off or becomes hard to read,
contact MK Diamond or your dealer for a replacement.
Decal/Label Location Description
A Motor - Side Caution - Receptacle is for Water Pump Only
B Motor - Side Caution - Use with GFCI only
C M otor - B ack Service/ Warranty
D Motor - Front Warning - Silica Warning
E Cutting Head – Top Warning - Read Owners Manual
F Motor - Front Notice - Voltage/extension cords
TILE SAW SPECIFIC WARNINGS
Wear eye protection.
Use splash guard for every operation for which it can be used.
Disconnect saw before servicing, when changing cutting blades, and cleaning.
Replace damaged cutting blade before operating.
WARNING
MK-370EXP SAFETY
Tile Saws
Receptacle is for
water pump only.
125V, .6 amps max.
! CAUTION
This saw is to be used
with a Ground Fault
Circuit Interrupter.
! CAUTION
Tile Master Label Sheet Part#166012
Label B
Label A
Label C
Label D
Label E
Label F
SERVICE OR
WARRANTY
FOR INFORMATION ON
PLEASE CALL
1-800-474-5594
WARNING
Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica in
their composition may give off dust or mists containing crystalline silica. Silica is a basic
component of sand, quartz, brick clay, granite and numerous other minerals and rocks.
Repeated and/or substantial inhalation of airborne crystalline silica can cause serious
or fatal respiratory diseases, including silicosis. In addition,California and some other
authorities have listed respirable crystalline silica as a substance known to cause cancer.
!
For Your Own Safety Read Instruction Manual
Before Operating Saw.
Wear Eye Protection.
Disconnect Saw Before Servicing, when Changing
Cutting Wheels and Cleaning.
Use Tool Only with Smooth Edge Cutting Wheels
Free of Openings and Grooves.
Replace Damaged Cutting Wheel Before Operating.
Do Not Fill Water Bath Above Water Fill Line.
See Manual for Pump Replacement.
! WARNING
NOTICE
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
25’
50’
75’
100’
150’
250’
Max. Cord Length
Max. Cord Length
Max. Cord Length No. 12 Wire
No. 10 Wire
No. 8 Wire
115v 230v
!
A
C
B
F
B
E