MK Diamond Products MK-370EXP - Manual (Page 33)

33
1/2-inch Wrench
(B)
Inspect Tile Saw
for damage
NOTE: If alignment problems are the result of a warped blade, a bent frame or bent support arm, or, if
alignment is off by more than 1/8-inch, contact the MK Diamond Service Center - (800) 474-5594
Combination Square
12-inch or Greater
Flat Head Screwdriver 1/4-inch Wrench
(A)
Remove Tile Saw
from Power Source
(C)
Inspect Diamond Blade
for damage
The Movable Cutting Table of the MK-370EXP is pre-aligned in the factory. It may become misaligned with
the Cutting Head of the Tile Saw over time. Should misalignment occur, perform the following steps to
realign it.
TOOLS NEEDED
PREPARATION
ALIGNMENT
MK-370EXP MAINTENANCE & TROUBLESHOOTING