MACKIE TT24 - Manual (Page 31)

Mackie TT24 Digital Live Console Owner’s Manual Addendum v1.7
31
DS3232 on a Card Slot SEND
This example shows the U100 Slot B: SEND set up in exactly the same way as shown for the
Slot A: RECEIVE on the previous page:
Here we have set the U100 Slot B SEND channel 1 so it will send only the DS3232 signal that
corresponds to our selections. Card B Send is ready to send DS3232 signals.
You will notice that when you select the DS3232 as your send, the U100 Slot A: RECEIVE will
also change to the same selection. This auto-fi lling-in of the receive side only happens if you
are sending a signal that does not originate from the host console. The card is getting ready to
send something it doesn’t have, so it gets ready to fi nd and receive it fi rst.
If, in the above example, we now set up to send a TT24 FOH Master signal, the receive side
will not change:
TT24 on a Card Slot RECEIVE
DS3232
1
Input
1 to 32
Pre-Fader
Select TT24, and the choices are:
FOH Master
FOH Slave
MON Master
MON Slave
Each of these selections has extra menus as
shown in the next few pages of this guide: