March Products 120 III (PC620) - Manual (Page 105)

User Manual version 2503
LIBRA 120 III (PC620 Intel 815E) 5-95
u RESET CONFIGURATION DATA
Normally, you leave this field Disabled. Select Enabled to
reset Extended System Configuration Data (ESCD) when you
exit Setup if you have installed a new add-on and the system
reconfiguration has caused such a serious conflict that the
operating system cannot boot.
The choice: Enabled or Disabled.
u RESOURCE CONTROLLED BY
The Award Plug and Play BIOS has the capacity to
automatically configure all of the boot and Plug and Play
compatible devices.
However, this capability means absolutely nothing unless you
are using a Plug and Play operating system such as
Windows  95. If you set this field to “manual” choose specific
resources by going into each of the sub menu that follows this
field (a sub menu is preceded by a “Ø”).
The choice: Auto (ESCD), Manual.
u IRQ RESOURCES
When resources are controlled manually, assign each system
interrupt a type, depending on the type of device using the
interrupt.
u IRQ3/4/5/7/9/10/11/12/14/15
ASSIGNED TO
This item allows you to determine the IRQ assigned to the
ISA bus and is not available to any PCI slot. Legacy ISA for
devices compliant with the original PC AT bus specification,
PCI/ISA PnP for devices compliant with the Plug and Play
standard whether designed for PCI or ISA bus architecture.
The Choice: Legacy ISA and PCI/ISA PnP.
u PCI/VGA PALETTE SNOOP
Leave this field at Disabled.
The choice: Enabled or Disabled.
PDF created with pdfFactory trial version www.pdffactory.com