March Products 120 III (PC620) - Manual (Page 41)

User Manual version 2503
LIBRA 120 III (PC620 Intel 815E) 3-31
3.1.3.6. CD-ROM Module Assembly
The LIBRA Kiosk provides enough space to accommodate a
slim CD-ROM or an equivalent device.
If a thermal receipt printer is integrated with the Kiosk, due
to space limitation, the slim CD-ROM device is to be installed
in the panel PC chassis as illustrated in Fig. 3-8 and accessed
from the right side of the Kiosk cabinet. If no receipt printer
is integrated with the Kiosk, the slim CD-ROM device can be
integrated with the media card reader module and accessed
from the front side.
Refer to Fig. 3-7. The following steps show the ways to install
a CD-ROM module before it is integrated to the panel PC.
1. Attach the CD-ROM board to the slim CD-ROM drive (A)
and fix them together with 2 screws.
2. There is a small metal bracket (B) used to firmly fix the
CD-ROM drive to the CD-ROM bracket. Retain the small
bracket to the CD-ROM drive first with two IMS M2*2.25
screws. This small bracket is to prevent the CD-ROM drive
from moving when installed to the CD-ROM bracket.
3. Insert the CD-ROM module with a small bracket on to the
CD-ROM bracket (C) and fix them together with two IMS
M2*2.25 screws and two PMS M3*5 screws.
F IGURE 3-7: S LIM CD-ROM M ODULE A SSEMBLY
(A)
(B)
(C)
(D)
PDF created with pdfFactory trial version www.pdffactory.com