Miele DG 4164 EN - Manual (Page 11)

Safety with children
~
The appliance must be installed at
such a height that small children cannot
reach the appliance door, which gets
hot during use.
~
Use the safety lock to prevent
children operating the appliance or
altering the settings.
~
The appliance is only intended for
use by adults who have read these
instructions. This appliance is not a toy!
To avoid the risk of injury, keep children
well away, and do not allow them to
play with it or use the controls. They will
not understand the potential dangers
posed by it. They should be supervised
whenever you are working in the
kitchen.
~
The appliance gets hot when in use
and remains hot for quite a while after
being switched off. To safeguard
against burning, keep children well
away from the appliance at all times.
~
Warning: Take care in the area
around the door hinge. Danger of
injury. Keep children well away.
~
Packaging, e.g. cling film,
polystyrene and plastic wrappings,
must be kept out of the reach of babies
and young children. Danger of
suffocation. Dispose of or recycle all
packaging safely as soon as possible.
Protecting the appliance from
damage
~
Do not use the appliance to heat up
food in sealed jars and tins. Pressure
will build up inside them, and they can
explode causing damage to the
appliance, as well as the risk of injury
and scalding.
~
Do not store cooked food in the
oven. The moisture in the food can lead
to corrosion in the appliance.
~
Do not use metallic containers or
utensils in the oven which are likely to
rust. This can cause corrosion.
~
Do not use a steam cleaner to clean
this appliance. The steam could reach
electrical components and cause a
short circuit. Pressurised steam could
also cause permanent damage to the
surface and to other components, for
which the manufacturer cannot accept
liability.
~
The appliance is designed to detect
and then self-correct certain
operational faults. If a fault is detected,
the fault messages
F06 to F95 will
appear in the display. The door of the
appliance can only be opened when
the fault message is flashing in the
display. If the fault message is not
flashing, the appliance is still
processing the fault. See "Problem
solving guide" for further information.
Warning and Safety instructions
11