Meyer Sound Matrix3 LX-300 - Manual (Page 37)

LX-ELC Ethernet/Wild Tracks
Provides Ethernet communications link between external hardware and the Matrix3 system. Also provides
a SCSI hard drive interface for use with Wild Tracks playback.
Ethernet connection is IEEE 802.3 and is 100 base T. Wiring must conform to EIA.TIA 568 standard with
CAT-5 or better cable.
Each LX-ELC module that is used for Wild Tracks requires a network connection to transfer audio files.
Wild Tracks drives provided by Meyer Sound do not have internal termination. An external terminator
must be used. LVD Ultra 160 active termination is provided.
Do not connect more than one LX-ELC to a SCSI bus. The LX-ELC is a SCSI controller and uses SCSI
ID 7. There can be only one controller on a SCSI bus.
Pin-out
Ethernet: Use standard CAT5 cabling.
SCSI disk connection: Ultra-SCSI. Use standard SCSI cabling. The connector is an Ultra2/SCSI VHDCI.
37
Component Specifications