Philips Magnavox MVR650MG/17 - Manual (Page 5)

Before Using Your VCR 5
Putting Batteries in the Remote Control
VCR maintenance
● In this VCR, use only tapes with the mark.
● Make sure any light adhesive stick-on notes are removed from
the videotape before putting the tape in the VCR. Removable
labels can jam the VCR.
● Periodic maintenance is required to maintain your VCR’s excellent
performance.This VCR has a built-in Automatic Head Cleaner.
However, the video heads will require replacement eventually. Only
an authorized service center should perform this service.
Using the Remote Control
● Point the remote at the VCR’s remote sensor (see page 21) when
using the remote to operate the VCR.
● Do not put objects between the remote and the VCR.
Recording Prevention
Videotapes have record tabs to ensure that recordings are not
erased accidentally.
1 To prevent recording, break off the tab with a screwdriver.
2 To allow recording, cover the hole with cellophane tape.
• Do not mix alkaline and man-
ganese batteries.
• Do not mix old and new batteries.
Helpful Hints
1
3
2
1
2
1 Remove the battery compartment lid on the bottom of
the remote by sliding the lid in the direction of the arrow.
2 Insert two AA batteries inside the battery compartment
with their + and – ends aligned as indicated.
3 Replace the battery compartment lid.