5. connecting the battery, 6. installing exhaust pipe, 7. connecting to weld output terminals – Miller Electric 280 NT User Manual
Page 21
OM-4402 Page 17
4-5. Connecting The Battery
Ref. 800 394-C / Ref. 203 073 / Ref. S-0756-D
+
−
3/8, 1/2 in
Y Connect negative (−)
cable last.
Tools Needed:
4-6. Installing Exhaust Pipe
801 681 / Ref. 203 073
Y Engine backfire can cause se-
vere burns or other injuries.
Do not point exhaust pipe to-
ward control panel. Keep
away from exhaust outlet.
.
Point exhaust pipe in desired di-
rection but always away from
front panel and direction of travel.
Tools Needed:
1/2 in
4-7. Connecting To Weld Output Terminals
Y Do not connect to CC and CV
terminals at the same time.
1
Work Weld Output Terminal
2
Stick/TIG (CC) Weld Output
Terminal
3
Wire (CV) Weld Output
Terminal
For MIG welding, connect work
cable to Work terminal and wire
feeder cable to Wire (CV) terminal.
For Stick/TIG welding, connect
work cable to Work terminal and
electrode holder cable to Stick/TIG
(CC) terminal.
801 943-B / Ref. 203 073
3
2
1