Muratec F-300 - Manual (Page 40)

2-4 G
ETTING STARTED
Selecting a function
To start setting a function, you must first press [Menu].
The two ways of selecting a function are described below.
The procedures described in this manual are using short-cut operations.
Short-cut operation with the numeric keys
Press [Enter], then press a three- or four-digit numbers to select the function.
For example, “Press [Menu], [2], [1], [0], [1], [Enter]”…
… you would press [Menu]
… then [2]
… then [1]
… then [0] (the numeric key zero)
… then [1]
… then [Enter]
Searching for a function using the cursor key
Even if you don’t remember the exact commands needed for an operation, you can search
for and enter the function using the cursor key ( , , , ).
To search for a function:
1
Press [Menu].
2
Search for the function using [ ], [ ], [ ] or [ ].
The function table on the next page may be useful for your search.
For example, if you want to set the “Cassette Size,” press [ ], [ ], [ ].
3
Press [Enter] when you have found the function that you want to set.
Going back to the previous screen by pressing [Back]
Press [Back] to go back to the previous menu level.