Muratec F-300 - Manual (Page 61)

3-9 A
UTODIALLER
& D
IALLING OPTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
A
UT
ODIALLER
& D
IALLING
OPTIONS
Call group dialing
If you frequently send the same fax message to several destinations, use call group
dialing. Call groups can store many one-touch keys and speed-dial numbers, so you can
broadcast the fax message by simply performing the group dialing operation.
Entering or changing a call group
Your machine can store up to 32 call groups.
1
Press [Menu], [1], [3], [1], then [Enter]. The empty call group number will be shown:
Enter Group No.
01:No Number Stored
2
Press [ ] or [ ] to select a call group number.
You can also select a call group by directly entering that two-digit identifier code (01-32).
3
Press [Enter].
01:Enter One-T/Speed
_
4
Enter the one-touch and speed-dial numbers you want to store into the call group
by pressing the one-touch key or [Speed Dial /Group] followed by three-digit code. A
comma will automatically be inserted between each number.
01:Enter One-T/Speed
[01],[03],S001_
If you want to enter all the one-touch and speed-dial numbers currently stored in your
machine, press [ ] without any characters.
01:Enter One-T/Speed
*_
5
Press [Enter].
01:Name ;Upper
_
6
Use the numeric keys to name the group number.
The name can hold up to 24 characters.
(Regarding how to enter characters, refer “Entering characters” on page 2-2.)
To change the name, press [ ] or [ ] to move the cursor, and press [Cancel] to erase
the name. Then enter the correct name.
7
Press [Enter] to save the setting.
The next empty call group will be shown.
8
To enter another call group, repeat this procedure from step 2.
To exit and return to the standby mode, press [Reset].
NOTE: To print a call group list, press [Menu], [5], [1], [0], [9], [Enter]. Then select group num-
ber and press [Enter].