Magellan 310 - Manual (Page 56)

Reference
Mark. If you select “Mark” and press ENTER, the Edit Waypoint
screen is displayed. You can now change any of the attributes for this
waypoint. Highlight “Save” and press ENTER to record this waypoint
into the memory of the Meridian.
View. Selecting “View” and pressing ENTER returns you to the Map
Screen in the Cursor Mode with the cursor on the address you entered.
From this point, you can create a waypoint by pressing and holding the
GOTO button.
Note: The address search has some limitations and is based upon the
map that was uploaded from the MapSend Streets software. While you
are entering the address you will notice that the available range is
displayed on the screen. Addresses entered must fall within that range.
Creating a GOTO Route — Creates and sets as the active route a 1-leg
route with your present position as the starting point and a destination
waypoint that you choose from the waypoint database.
Any
Select
“Find By”
Select ENTER
ENTER From
Screen
Waypoint
Category
Use left/right
arrows to select
If a GOTO route
already exists, you will
be asked to clear it.
Waypoint
from List
GOTO
GOTO routes are not saved in memory. When you turn your Meridian
off and then back on, the GOTO route is gone. You need to create a
new GOTO route if you intend on completing the route.
Also note that when you are selecting the Waypoint Category you are
being instructed to select the “Find By”. You can select only those
waypoints in your general vicinity (Nearest) or all of the waypoints in
the category in alphabetical order (Alphabetical).
Creating a Backtrack Route — Creates a route using track information
stored in the Meridian to “retrace” your steps. A good example of using
a backtrack would be if you were out hiking or jogging with your
Meridian turned on and computing position fixes. After 30 minutes
46 Magellan Meridian GPS Receiver