Magellan 310 - Manual (Page 57)

Reference
you choose to return to where you started, following the same route you
just took. All you need do is follow the instructions below and let the
Meridian take you there.
Any
MENU Highlight
Routes
Select
Highlight ENTER
ENTER ENTER From
Screen
“Backtrack”
from Route List
Activate Backtrk
Creating a Multileg Route — Provides the means to create a multileg route
that can be stored in memory.
Multileg routes are easily the most complicated function in the
Meridian, but once you can visualize what a multileg route (route) is, it
becomes very easy to understand and create. If you understand that a
GOTO is a 1-leg route with a starting point and a destination point,
then imagine a bunch of GOTO’s strung together where the destination
of one GOTO is the starting point for the next GOTO. That means if
you had three GOTO’s, one from “A” to “B”, another from “B” to “C”
and a third from “C” to “D” you could then put them together to make
one multileg route. In this example you would have a 3-leg route that
went from “A” to “B” to “C” to “D”.
A
B
C
D
Leg 1
Leg 2 Leg 3
These routes have an advantage over GOTO’s in that A) the starting
point does not have to be your present position, B) they are always in
memory and if activated they remain activated, even when you turn the
Meridian off and then back on, and C) they can be saved and used over
and over again.
(Note: these routes have been termed “multileg” in an effort to make
the understanding of them a little clearer, however you could create a
1-leg route and save it in the Meridian’s memory.)
Magellan Meridian GPS Receiver 47