Motorola PageWriter 2000X - Manual (Page 23)

16 PageWriter 2000X User’s Guide
To recharge the battery outside of the pager:
1. Insert the transformer’s round connector into the back of the
charger.
2. Insert the transformer’s two-pronged plug into any standard
120 Vac power supply outlet.
3. Place the 3.6 V NiMH battery in the charger’s battery compart-
ment by aligning the positive (+) and negative (-) markings on
the battery with those on the charger.
4. Press the battery firmly into place. The lit red LED indicator
light means that the battery is charging.
Ä
A flashing red LED indicator means the battery is not making
a good contact. Ensure the pager is properly seated in the
charger.
5. When the green LED indicator becomes lit, the battery is fully
charged. Remove the battery from the front of the charger.
TIP Leaving the battery in the charger after the LED turns green
keeps the battery fully charged until removed. Keep your
spare battery fully charged by leaving it in your plugged-in
charger.
Transformer
Two-pronged Plug
Transformer
Round Connector
Battery
Compartment
PWContents.book Page 16 Thursday, July 8, 1999 11:57 AM