Motorola PageWriter 2000X - Manual (Page 63)

56 PageWriter 2000X User’s Guide
To establish a connection between your pager
and FLEX PC Partner on your PC:
1. Snap your pager into the docking station. For information on
connecting the docking station to your PC, see “The Infrared
Port” on page 17.
2. On your pager, select from the menu wheel.
3. Select .
4. If this is the first time the FLEX PC Partner application is being
installed on your PC continue to the next section, "Configuring
FLEX PC Partner". Otherwise, see “Using the PC Partner
Shell” on page 57.
Configuring FLEX PC Partner
The FLEX PC Partner Configuration utility is run immediately
after installing FLEX PC Partner. It tells the FLEX PC Partner
application how your pager will be connecting to your PC. If you
change hardware (e.g., replace the charger with a new type of
charger) reconfigure the FLEX PC Partner application using the
following procedure.
To configure FLEX PC Partner:
1. From your desktop, double-click FLEX PC Partner.
-or-
From the Windows 95 taskbar, click Start, then point to
FLEX PC Partner and click FLEX PC Partner.
2. From the PC Partner Shell, double-click Partner Con-
figuration.
3. From the FLEX PC Partner Configuration dialog box, select the
appropriate serial port.
Ä
If the port selection is not correct, an error message appears
(“No IR devices found”).
4. In the Adapter list box, select the appropriate adapter.
5. Click OK. If this is not the first time FLEX PC Partner has been
configured to your PC, click Yes to save your choices and close
the FLEX PC Partner Configuration partlet.
PWContents.book Page 56 Thursday, July 8, 1999 11:57 AM