Miro Displays TD570 - Manual (Page 12)

S PECIFICATIONS
LCD Type 17” diagonal viewable screen
TFT (Thin Film Transistor),
Active Matrix Panel, 0.264mm pixel pitch
Color Filter R, G, B vertical stripe
Colors up to 16.2 millions (6bit+dithering)
Glass surface Anti-glare coating
Viewing
Angles
Left / Right 70° / 70°
(CR>10) Up / Down 65° / 65°
Contrast Ratio Typ. 450 : 1
Luminance of White Typ. 260cd/m²
Response Time Typ . Tr: 9 ms; Tf: 16 ms
Compatibility PC IBM XT, AT, 386, 486, Pentium or PS/2
and compatibles (from VGA up to
1280 x 1024 @ 75 Hz NI.)
Refresh Rate Max. 1280 x 1024 @ 75Hz NI
Connectors Input Signal 15-pin D-SUB
Power Input AC 90-264V 50-60Hz
Consumption 45 watts (Maximum)
Display Area Max. 338mm (H) x 270mm (V)
Operating Temperature 32°F to 104°F (0°C to 40°C)
Humidity 20% RH to 90% RH (no condensation)
Altitude To 10,000 feet
Storage Temperature -14°F to 104°F (-20°C to 40°C)
Conditions Humidity 5%RH to 90%RH (no condensation)
Dimension mm 374 (W) x 366 (H) x 195 (D)
Weight Net 4.6kg
14 15
T ROUBLESHOOTING
No power.
ü Flip the power switch ON. The Power LED turns on.
ü Make sure AC power cord is securely connected to the power jack
and to a power outlet.
Power on but no screent image.
ü Make sure the video cable attached with this monitor is tightly
secured to the video output port on the back of the computer.
ü Adjust the brightness and contrast.
Image is unstable, unfocused.
ü Use “AUTO-TUNE” to adjust automatically.
ü If the image is still unstable after “AUTO-TUNE” processing,
please adjust “PHASE” manually to get image focused.
ü Check whether the resolution or refresh rate in windows display
setting is beyond supported range(please refer to the specification
of supported mode).
Flickering.
ü Not enough power is being supplied to the miro TD570 Monitor.
Connect the miro TD570 Monitor to a different outlet. If a surge
protector is being used, there may be too many devices plugged in.
ü See Timing Guide in this manual with a list of refresh rates and
frequency settings showing the recommended setting for the
miro TD570 Monitor.
Wrong or abnormal colors.
ü If any colors (Red, Green, or Blue) are missing, check the video
cable to make sure it is securely connected. Loose pins in the
cable connector could cause a bad connection.
ü Connect the miro TD570 Monitor to another computer.
ü Check the graphics card for proper sync scheme (or sync
polarities) to match the miro TD570 Monitor’s specifications.
En
gli
sh
En
gli
sh