Miro Displays TD570 - Manual (Page 9)

M ENU D ESCRIPTIONS
OSD P OSITION
Select this control to center the image horizontally and
vertically on the screen.
OSD T IMEOUT
Select this control to set the displaying time of OSD.
M
EMORY
R
ECALL
Reset default factory settings of
Clock, H/V Position, Phase,
Contrast, Brightness, Color tempera -
ture, OSD position, OSD timeout and
Sharpness.
* Note:
You can get the best quality of the image under full-screen image with a running
computer. The function of AUTO-ADJUST may not work properly if background color
is dark or if the input image does not fill the screen. (ex: DOS text mode)
We strongly recommend that you just run the AUTO-ADJUST function to get the
best image quality when you unpack the monitor or when you install different VGA
card or PC.
M ENU D ESCRIPTIONS
I
NFORMATION
To display the data about Horizontal /
Vertical frequency, Pixel clock,
Resolution, Model number and Serial
No. of the monitor.
I MAGE A DJUST
Select this control and then use the
and select buttons to adjust the
screen image until it looks focused,
crisp and sharp.
H
ORIZONTAL
/ V
ERTICAL
P
OSITION
Select this control to center the image horizontally and
vertically on the screen.
H ORIZONTAL S IZE
Select this control to expend or decrease the image width
to horizontally fill the display screen.
F INE T UNE Select this control to adjust the delay time of data and
clock
S HARPNESS Select this control to adjust the picture sharpness of display
S
ETUP
M
ENU
You can choose where you would like
OSD image to appear on your screen.
L ANGUAGE S ELECT
Select this control to choose on of the seven language
you need.
R
ESOLUTION
N
OTICE
Enable: OSD will Notifier the best picture quality
resolution change the resolution to 1280 x 1024.
8 9
Information
H.Frequency: 79.99 kHz
V.Frequency:
75.03 Hz
Pixel Clock: 135.04 MHz
Resolution: 1280 x 1024
Model Number: miro TD570
Serial No: 129040800001
1:EXIT
Image Adjust
H./V.Position
H.Size
Fine Tune
Sharpness
1:EXIT 2:SELECT
Setup Menu
Language Select
Resolution Notice
OSD Position
OSD Time Out
OSD
1:EXIT 2:SELECT
M e m o r y R e c a l l
En
gli
sh
En
gli
sh