Motorola VT1000v - Manual (Page 16)

10
Installation With A Home Network
1 Be sure your Motorola voice terminal is unplugged. Be sure power is off to your
broadband modem (cable or DSL) and router.
2 Connect one end of an Ethernet cable (RJ-45) to an open Ethernet LAN port on
your router. Follow the instructions provided with your router. Connect the other end
of this Ethernet cable to the WAN connector on your Motorola voice terminal.
3 Connect a telephone to your LINE 1 connector using a phone wire (RJ-11). For a
VT1005v only, you can connect a second telephone to the LINE 2 connector.
4 Power on your broadband modem, following the instructions provided with the
modem. Wait about two minutes for it to boot.
5 Power on your router, following the instructions provided with the router. Wait about
two minutes for it to boot.
6 Plug the AC power adapter to the POWER connector on your Motorola voice
terminal and the electrical outlet. This turns your Motorola voice terminal on. You do
not need to unplug it when not in use.
7 Check that the POWER light on your Motorola voice terminal turns on solid green.
Wait about two minutes for the Motorola voice terminal to boot.
Broadband
Modem
Motorola
voice
terminal
Router
Computer
See “Connecting a Computer to
Display the Configuration Pages”
WAN
Computer
PC LINE 1
Computer
(only if
necessary)
Phone
Ethernet port
LAN ports
VT1000User.book Page 10 Monday, November 3, 2003 4:19 PM