Motorola VT1000v User Manual
Page 18
Advertising
12
Connecting a Computer to Display the
Configuration Pages
For an Installation With A Home Network only, you need to connect a computer with
DHCP enabled to the Motorola voice terminal to display the configuration pages. For
information about enabling DHCP, refer to your operating system documentation.
If you performed an Installation With A Single Computer, a computer is already
connected to the Motorola voice terminal.
To connect a computer to the back of the Motorola voice terminal:
1
Connect one end of an Ethernet cable to the PC connector on the Motorola voice
terminal.
2
Connect the other end of the Ethernet cable to the Ethernet connector on a
computer.
3
Power up the computer.
VT1000User.book Page 12 Monday, November 3, 2003 4:19 PM
Advertising