Motorola MICOM-2ES/2RS/2TS ALE - Manual (Page 54)

MICOM-2ES/2RS/2TS ALE Supplement to Owner’s Guide
➤ To define or change a group:
1. Press CALL (F1) and select the GRP option, as you do to start a group call
(page 38).
2. The first group displayed is always group 1. If this
is the group you want, skip directly to Step 3 below,
otherwise press the UP or DOWN arrows until you
see the desired group.
CALL
GRP 1
MOTOROLA
SEND PAGE CHAN SEL s
3. To select the stations you want in this group, press SEL (F4).
Note
The following example explains how to build a new group, but you
can use the same procedures to change an existing group.
4. After pressing SEL (F4), you will see the DIR
screen. Therefore, you can select stations from the
addresses already stored in the directory, or type
new addresses using the keypad.
DIR
1005
MOTOROLA
ADD PAGE CHAN OK s
To select an address from these already in the directory:
• Use the UP and DOWN arrows to display the desired directory entry,
and then press ADD (F1).
The label above the selected entry changes to
ADDED, to indicate that it is now included in
the group.
Now you can also have the option (
ERAS (F1))
to delete the entry from the group.
ADDED
1007
MOTOROLA
ADD ERAS CHAN OK s
Note
If adding the station would cause the
total length of the station addresses in
the group to exceed 12 ALE words, then
after pressing
ADD (F1) you will see
BUFF FULL and the process stops.
GROUP
BUFF FULL
MOTOROLA
ADD ERAS CHAN OKs
• Repeat the procedure described above until the
group includes only the desired stations.
40
_________________________________________________________________________________________________