Musical Fidelity KW250S - Manual (Page 13)

KW250S
CD SPECIAL FEATURES
Issue 3: 12th July 2006 Page 13 of 25
INVALID TRACK
program 2 track 9
PLAY 1 0:41
play program
Remember that when entering a single-digit track number,
there is a delay of about two seconds before the display
accepts the entry - this is to allow time for a second button to
be pressed when a double-digit number is required.
If an incorrect entry is made, say track 99 when there are only
7 tracks available on the disc, a brief error message is
displayed
If at any time you wish to add a track to the list, press the
CLEAR button to obtain the next step number. Alternatively,
to delete a previous entry, press CLEAR a second time to
remove the last entry. Repeated pressing of CLEAR will
then erase each step in reverse order. So to delete an entire
program sequence from the memory, press CLEAR
repeatedly until “prog 1” is shown in the display.
When the last track number has been entered, press
PROGRAM a final time, then the PLAY button to start the
program sequence.
If you wish to check the selection before playing back your
program, the CHECK button can be pressed to step through
each program entry in turn.
If during this check sequence the PLAY button is pressed, the
remaining part of your programmed selection will play to the
end of the sequence.
Otherwise, to play all the programmed tracks from the
beginning of the sequence, press PLAY/PAUSE, or PLAY
on the remote control.
The >>| button may be pressed to jump to the next track in
the programmed sequence, or
|<< button to obtain the previous track in the sequence.
When all programmed tracks have been played, the CD player
stops. The same track selection can then be played again by
pressing the PLAY/PAUSE button on the front panel, or
PLAY on the remote control.
To repeat a programmed sequence continually, press
REPEAT whilst playing the program.
To cancel this mode, press PROGRAM.
Note: The program contents will be cleared if you switch off
the power, or open the disc drawer and load another disc.
If, however, the same disc is loaded again with the power
still switched on, the program sequence is retained in the
memory.
DISPLAY
KW250S display brightness can be controlled in three
levels by pressing the DISPLAY button on the remote
control.
The original setting is maximum brightness, but by pressing
the DISPLAY button once, brightness is reduced, and a
further press turns the display off. This controls display in
CD, TUNER, and external source modes.