Musical Fidelity KW250S - Manual (Page 17)

KW250S
FM FUNCTION BUTTONS
Issue 3: 12th July 2006 Page 17 of 25
PS: FM
Preset 1 saved
105.80MHz FM
PS: FM
Radio 1
PS: FM
Radio 1
PS: FM
Radio 1
PS: FM
Preset 1 empty
AUTO-TUNE
To auto search stations, press the AUTO TUNE
button. The tuner will search upwards through the FM
band and pick out the next station for you.
If pressed and held for more than a second, the tuner
will scan back down the band to the previous station
(the scan-down function is not available on the remote).
BAND
This button alternates the tuner between receiving FM
and DAB stations
TUNE UP/DOWN
To manually tune to a station, simply turn the left-hand
knob to cycle through the FM band. Turning slowly
gives fine-tuning steps (50kHz).
When the required station frequency is displayed, the
station should be heard, and after a few seconds radio
text information is displayed, if available.
See the section on the PRESET buttons to store
favourite stations for easy recall
PRESET UP and PRESET DOWN
PRESET UP/DOWN buttons are used to select one of
ten FM preset memory locations. Press select when the
desired preset is displayed.
STORE
It is possible to store favourite stations in preset
memory locations using the STORE button as follows:
Tune to the station required:
Press PRESET UP/DOWN buttons until the desired
preset is displayed.
Press and hold STORE to accept this preset. The
display will indicate the preset has saved
and then revert to selected station.
Note: this will overwrite any station stored previously
on this preset.
Briefly pressing the button will display current preset
without storing. There are 10 presets available for
programmes on the FM band (in addition to the 10
provided for DAB). Presets are remembered even if the
unit is switched off.
MONO/STEREO (remote only)
This button enforces mono reception when inadequate
aerial signal strength results in noisy stereo reception.
MONO ‘forces’ mono at all times until the button is
pressed again for AUTO. In AUTO mode, the tuner
automatically switches according to signal strength.
INFO
Displays the current broadcast information in the
following order:
PI: Programme identification*
PTY: Programme type*
RT: Radio text*
CT: Clock date and time (as transmitted by network)*
MS: Music/Speech (info only)*
DI: Decoder information*
Signal Strength with bar graph
Audio mode
AF: Alternate frequency*
- Returns to top of this list
* Relies on FM RDS. Not displayed if no or insufficient
RDS signal.
MENU (FM options)
Press MENU to access menu options whilst in FM
mode.
Use the TUNE up/down knob to cycle through the
options, and the SELECT button to choose displayed
option.
Menu options available for FM are:
System reset: RESETS all presets and tuning to
87.50MHz (beginning of FM Band)
Customer Version: Current software version