Metrologic Instruments MS7220 - Manual (Page 42)

39
MS7220 S TANDS
Optional Flexible Stand Installation [ MLPN 46-46404 ]
Remove the three screws
securing the cable cover to the
unit and slide it up and off the
scanner. Disconnect the cable
and slide the horizontal stand
up and off the unit. Disassemble the horizontal stand. Remove
the lock nut and the short coupler. They will
not be used on the flex stand.
Mounting the MS7220: Peel off the base plate’s tape backing and affix it to the
countertop or drill four #39 pilot holes and secure the base plate to the
countertop with the four #8 wood screws provided.
Slide the bearing plate over the
stud on the base plate then
attach the flex pole. Slide the bellows over the flex pole and
cable. Position the long coupler over the
top of the bellows. Secure the long coupler
in place with the ¼-20 pan head screw
provided then position the foam insert over
the screw head.
Slide the flex stand on the unit. Reconnect the cable and secure the cable
cover with the three M3 screws.