Metrologic Instruments MS7220 - Manual (Page 9)

6
Figure 2: OCIA, Interface powered by
the host device
OCIA
I NSTALLATION FOR OCIA I NTERFACE (C ONTINUED )
To power the unit from the host device:
(
For OCIA only)
1. Follow the “Getting Started” steps on
page 3.
2. Turn off the host system.
3. Connect the PowerLink cable to the
jack labeled “OCIA” on the MS7220.
4. Connect the other end of the
PowerLink cable to the host.
Before continuing verify that the
powerlink cable is connected to the
proper communication jack on the
scanner. Incorrect cable connection
can cause communication problems
or potential damage to the scanner.
Manufacturers Note:
Plugging the scanner into the serial
port of the PC does not guarantee
that scanned information will appear
at the PC. A software driver and
correct configuration setting are also
required for proper communication
to occur.
5. Slide the cable cover into place on
the back of the scanner then secure it
with the three M3 screws provided.
6. Turn on the host system.
7. Scan the bar code to configure the
MS7220 for OCIA communication.
³ 9 9 9 9 9 3
Load OCIA Defaults
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet the
requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the power source
should meet applicable performance requirements for a limited power source.