Transition/electrostatic tower assembly – MartinLogan E2 User Manual
Page 10
Advertising
10 Assembly
Note: The following instructions describe the assembly of
the right channel high-and mid-frequency tower. Duplicate
all assembly instructions for the left tower assembly.
1
Attach the outside (semi-circle shaped) trim rail to the
transition tower by aligning the five pins on the trim
rail with the 5 cam holes in the tower.
2
Use a phillips head screwdriver to rotate the cams a little
over 180° counter clockwise once the pin is properly
aligned in the cam. The arrow on the cam must be in
the position shown to accept the pin.
3
Make sure the trim rail is flush with the tower edge.
Transition/Electrostatic Tower Assembly
Figure 15
Figure 16
Figure 17
Advertising