Multiplex Technology 8CH - Manual (Page 53)

50
• • Step 1 Step 1 Connect the connector with the HDD (refer to Picture 1).
• • Step 2 Step 2 Put HDD into the HDD cartridge. Please notice the bottom side is power side
as chart shows (refer to Picture 2).
• • Step 3 Step 3 Screw the HDD to the cartridge. Before you screw the HDD, please be aware
that you must to level pin 1 of the HDD at pin 1 mark, because the screw hole is
different from different HDD brands. Then screw the HDD correctly (refer to Picture 3
and 4). You must precisely align the hard disk to the pin connection to ensure correct
installation.
• • Step 4 Step 4 Reverse the HDD and put it into DVR (refer to Picture 5 and 6).
• • Step 5 Step 5 Connect the HDD with DVR (refer to Picture 7).
• • Step 6 Step 6 Lock the cabinet by turning the key clockwise (refer to Picture 8).
A ( locked )
B ( unlocked )
• • Step 7 Step 7 Close the cap (refer to Picture 9).
4CH
Carefully following the steps to ensure correct installation.
*** Note: Please set one HDD to “Master Mode” or “Single Mode” ***
Note : If you do not lock the cabinet, the DVR system will not function properly.