Moxa Technologies NPort 5400 - Manual (Page 76)

NPort 5400 Series User’s Manual Configuring NPort Administrator
6-20
COM Mapping
Windows Administration Suite comes with Windows 95/98/ME/NT/2000/XP Real COM drivers.
After you install NPort 5400 Administration Suite, there are two ways to set up the NPort 5400
serial port as your host’s remote COM port.
The first way is with On-line COM Mapping. On-line COM Mapping will check to make sure
that the NPort 5400 is connected correctly to the network, and then install the driver on the host
computer.
The second way is with Off-line COM Installation, without first connecting the NPort 5400 to
the network. Off-line COM Mapping can decrease the system integrator’s effort by solving
different field problems. Via off-line installation, users can first process software installation for
the host, and then install the NPort 5400 to different fields.
Use the following procedure to map COM ports:
1. On-line COM Mapping:
Connect NPort 5400 to the network Æ Set NPort 5400 to the proper IP address Æ Map
COMs to your host Æ Apply Change.
2. Off-line COM Mapping:
Map COMs to your host Æ Apply Change Æ Connect NPort 5400 to the network Æ
Configure NPort 5400’s IP address.
On-line COM Mapping
1. Broadcast Search for NPort 5400s on the network.
2. Select the COM Mapping function group.