Mustang Survival MD3082 - Manual (Page 14)

removed prior to re-arming.
5) Check the housing to be sure it is clear and dry. If necessary, rinse
the inflator with fresh water to remove dirt and salt. Let dry before
going to step 6.
CO
2
Cylinder
Step 2
Cylinder /
Bayonet
Assembly
Step 2
Sensor Ring
Step 9
Bayonet
Tab
Step 9
O-ring
Step 9
HOUSING**
Step 4
Service
Indicator
Step 11
Pull-Tab
Lever
Step 10
Yellow Bobbin
(white side up)
Step 4
Housing
Shoulder
Step 8
Cap
Step 3
Pins
MD3083 and MD3084 Automatic Inflator
FIGURE 10
6) Inspect the bobbin. If the bobbin has been fired or damaged, replace
it! Ensure the new bobbin is valid, it must have been purchased
within the last three (3) years. If the bobbin purchase date is
11 Inflatable PFD Owner’s Manual