Mustang Survival MD3082 - Manual (Page 23)

1) No spare parts or re-arming kits are needed to test an Inflatable PFD.
2) Remove the CO2 cylinder/bayonet assembly to prevent inadvertent
inflation, which could potentially damage the Inflatable PFD. Inspect
the cylinder to confirm it is unused (Fig. 11). Unscrew and remove
the cap and the bobbin (MD3083 and MD3084 only). Otherwise the
bobbin will disintegrate during water immersion.
3) Put on the Inflatable PFD.
4) Get into shallow water, just deep enough that you can stand with
your head above the surface.
5) If you are a weak swimmer or non-swimmer, inflate the Inflatable
PFD partially so that you are supported well enough to be able
to complete inflation without touching bottom, either orally or
manually. Note this level of inflation because it is the minimum
needed for you to safely use this Inflatable PFD.
6) Fully inflate the Inflatable PFD using the oral inflator.
7) See if the Inflatable PFD will float you on your back or just slightly
back of vertical. In a relaxed floating position, verify that your mouth
is well above the water’s surface. Note the effect of where you hold
your legs on how you float.
8) Get out of the water and remove the Inflatable PFD. Completely
deflate the Inflatable PFD using the oral inflator.
9) Let the Inflatable PFD dry thoroughly. Re-arm (for your model) and
Repack the PFD (p. 13).
WEAR YOUR PFD
In approximately 80 percent of all boating fatalities, the victims were not
wearing a PFD. Most fatal accidents happen on calm sunny days. This
Inflatable PFD is much more comfortable to wear than other PFD types.
Get into the habit of wearing this Inflatable PFD.
Non-swimmers and children especially should wear a hybrid or non-
Inflatable PFD at all times when on or near the water.
HYPOTHERMIA
Prolonged exposure to cold water causes a condition known as
Inflatable PFD Owner’s Manual 20