Mustang Survival MD3082 - Manual (Page 15)

unknown, check the date printed on the bobbin and replace if
older than three (3) years (see Re-arming Your PFD (MD3083 and
MD3084), p. 10).
7) IMPORTANT! Bobbin (yellow) must be installed into the HOUSING
(**see figure 10), white side up, aligning the slots on the bobbin
with the ridges inside the threaded housing. The bobbin will slide in
easily if installed correctly.
8) Install cap by screwing clockwise until it meets the housing shoulder.
9) Check the new cylinder/bayonet assembly to ensure the o-ring is in
place and the sensor ring is attached (Figs. 10 and 11). Ensure that
the CO2 cylinder has not been pierced (Fig. 11).
Solid
Cylinder
Top
Attached
Sensor
Ring
Pierced
Cylinder
Top
Broken
Sensor
Ring
Caution: Do not use
the cylinder/bayonet
assembly if either
the o-ring or sensor
ring is broken,
missing or damaged.
FIGURE 11
IMPORTANT: You will damage the sensor ring if bobbin and
cap are not installed first.
10) Push, and hold, the lever into the inflator housing. The pull-cord
should be situated in the groove (Fig. 12). Install a new cylinder/
bayonet assembly by engaging bayonet tabs in housing, pushing in
then turning clockwise 1/8 turn to a full stop (Fig. 12).
11) Examine the service indicator (Fig. 10) and ensure it is GREEN. If
the service indicator is red, the mechanism has been fired or is
incorrectly fitted and the inflator requires service. See
Re-arming Your PFD (MD3083 and MD3084) (p. 10).
NOTE: The service indicator must be green before proceeding.
Inflatable PFD Owner’s Manual 12
WARNING: PFD WILL ONLY INFLATE IF CYLINDER IS
TURNED TO A FULL STOP.