11a-8-7, 4g9 engine (e-w) – Mitsubishi Motors 4G9 User Manual
Page 108
www.mivec.co.nz
4G9 ENGINE (E-W) -
Rocker Arms and Camshafts
11A-8-7
PWEE9502
E
May 1995
Mitsubishi Motors Corporation
(3) The bearing caps No. 2 through No. 5 are of the same
shape. Before they are installed, check the cap number
and the intake and exhaust identification marks.
Identification mark (stamped on front and No. 2
through No. 5 bearing caps)
L: Intake side
R: Exhaust side
(4) Make sure that the rocker arms are installed in the
specified locations.
"IA BEAM CAMSHAFT CAP INSTALLATION
(1) Locate the camshaft dowel pin as illustrated.
(2) Turn the crankshaft anticlockwise a quarter turn (90_).
(3) Apply a 3 mm thick continuous bead of sealant to the
bottom surface of the beam camshaft cap along the
groove.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
PWEE9502-G
E
May 2000
Mitsubishi Motors Corporation
Revised
Cap No.
IN or EX side
identification
Dowel pin
<DOHC-GDI for CARISMA (Up to 2000 model),
SPACE STAR (1999 model), SPACE RUNNER>
Dowel pin
<DOHC-GDI for CARISMA (From 2001 model),
SPACE STAR (From 2001 model), GALANT,
PAJERO io>
Approx.
150_
Approx.
106_
Beam camshaft cap
3 mm
<DOHC-GDI for CARISMA (Up to 2000 model),
SPACE STAR (1999 model), SPACE RUNNER>
Timing belt side
<DOHC-GDI for CARISMA (From 2001 model), SPACE STAR
(From 2001 model), GALANT, PAJERO io>
Beam camshaft cap
3 mm