Mitsubishi Motors 4G9 - Manual (Page 95)

www.mivec.co.nz
4G9 ENGINE (E–W) – Water Pump and Water Hose
11A-7-6
PWEE9502
E
May 1995 Mitsubishi Motors Corporation
"
F
A
ENGINE COOLANT TEMPERATURE GAUGE UNIT
INSTALLATION
(1) Apply the specified sealant to the threads.
Specified sealant:
3M ATD Part No.8660 or equivalent
"
G
A
ENGINE COOLANT TEMPERATURE SENSOR
INSTALLATION
(1) When reusing the sensor, apply the specified sealant
to the threads.
Specified sealant:
3M Nut Locking Part No.4171 or equivalent
" H A WATER BY-PASS FITTING INSTALLATION
(1) Apply 3 mm diameter of Form-In-Place Gasket (FIPG)
to the location shown in the illustration.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent.
"
I
A
WATER FITTING INSTALLATION
(1) Apply 3 mm diameter of Form-In-Place Gasket (FIPG)
to the location shown in the illustration.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent.
PWEE9502-K
E
Jun. 2002 Mitsubishi Motors Corporation Added
<REAR WHEEL DRIVE>