Mitsubishi Motors 4G9 - Manual (Page 134)

www.mivec.co.nz
4G9 ENGINE (E - W) - Cylinder Head and Valves
11A-9-7
PWEE9502-A
E
Nov. 1995 Mitsubishi Motors Corporation Revised
"
B
A
VALVE SPRING INSTALLATION
(1) Install the valve spring with the painted end on the rocker
arm side.
"
C
A
RETAINER LOCK INSTALLATION
(1) The valve spring, if excessively compressed, causes the
bottom end of retainer to be in contact with the stem
seal, and damage it.
"
D
A
CYLINDER HEAD BOLT INSTALLATION
(1) When installing the cylinder head bolts, check that the
shank length of each bolt meets the limit. If the limit
is exceeded, replace the bolts.
Limit: Max. 96.4 mm
(2) Install the washers as illustrated.
(3) Apply engine oil to the bolt threads and washers.
Painted
end
Spring
retainer
Stem seal
Spring seat
MD998772
Except
MIVEC
MD998772
MIVEC
MD998784
MD998735
Shank length