Motorola VL50 - Manual (Page 28)

Cloning Radio Settings
27
Cloning Radio Settings
You can copy VL50 radio settings from one radio (the source) to a second radio using the
56531 Multi-Unit Charger (MUC) optional accessory. See the MUC User's Guide for more
information.
You can clone only one radio at a time. A multi-channel radio can clone to a single-channel
radio, but only the first channel is cloned. The MUC does not have to be plugged in for cloning,
but both radios require charged batteries.
1. On the source radio, press and hold Push to Talk and
T for 3 seconds while turning the
radio on. The radio beeps and displays k .
2. Place the source radio in one of the charging pockets.
3. Turn the target radio on and place it in the charging pocket that is
paired with the pocket containing the source radio. There are
3 paired charging pockets as indicated by the 3 pairs of charging
status LEDs.
4. Press and hold T on the source radio. The source radio transmits its
settings to the target radio. If cloning was successful, P or Pass
displays on the source radio and the target radio displays all feature
icons. If cloning was not successful, F or Fail displays on the source
radio.
5. Turn the target radio off and back on again to use.
6. To clone another radio, repeat steps 3 and 4.
7. To exit programming mode on the source radio, press and hold
Push to Talk until k
no longer appears.
031102o
LEDs
Paired
pockets
VL50operation.fm Page 27 Thursday, February 26, 2004 2:51 PM