Metrologic Instruments IS8000 Series - Manual (Page 11)

7
I NSTALLING THE S CANNER TO THE H OST (O PTIONAL F EATURES )
Hand-held Port Option
A Non-Decode Hand-Held Scanner can be connected to an IS8000 series fixed
scanner.
To avoid potential problems, do not power up the scanner until the
communication cable is secured to the host.
1. Turn off the host
system.
2. Connect the
communications cable
to the HoloTrak
® and to
the host.
3. Connect the
communication cable of
the hand-held scanner
to the HoloTrak.
4. Check the AC input
requirements of the
power supply for the
scanner to make sure
the voltage matches
the AC outlet.
5. Connect the power
supply to the HoloTrak.
6. Plug the power supply
into the AC outlet.
7. Power up the host
system.
When the hand-held scanner first receives power, it will immediately go
through a self-diagnostic routine, then the green and red LEDs will flash,
and the unit will beep once.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet
the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the power
source should meet applicable performance requirements for a limited power source.