Metrologic Instruments IS8000 Series - Manual (Page 16)

12
V ISUAL AND A UDIBLE I NDICATORS
When the scanner is on, the activity of the red and green LEDs
indicate the status of the scanner.
Flashing Red, No Green
During power-up and diagnostic mode.
Steady Red, No Green
Unit has completed power-up, the VLD is emitting
light, and the unit is ready to scan.
Steady Red, Green Flash
When the scanner transmits a successful read, the
green LED will flash. Generally, if the green LED does
not flash, then the bar code has not been successfully
read. If handshaking is being used, the green LED
goes out when proper handshaking has completed.
When the green light turns off, communication to the
host is complete.
Alternating Red and Green with razz tone
This indicates a motor failure.
Steady Red, Green Flashing with a beep
Scanner has entered program mode successfully.
(See Running the MetroSet
® 2 Program for more
details on configuring the scanner).
Steady Red, Green Flashes 3 times with 3 beeps
Scanner has exited program mode successfully.
Note: If the scanner has been configured for reverse
LED convention, via MetroSet 2, all mode
indicators described above also reverse.