Siemens A57 - Manual (Page 9)

©
Sieme
ns
AG
2003, C:\Projekte
\Siem
en
s\10210-0
01\A5
7\Produkt\A57
_sug_v
2_en_04
0519_b
w
_p
k_druck\Ja
gua
r_
Ma
in.fm
left page (8) of A57 Jaguar, short, en, A31008-H5830-A1-2-7619 (24.06.2004, 06:24)
Switch on/off, PIN entry 8
VAR Langua
ge: en; V
A
R issue
date: 040528
this range). The voltage specified on the
power supply unit must not be exceeded.
To use the full performance of the bat-
tery, the battery must be fully charged
and discharged at least five times.
Charge icon not visible
If the battery is totally discharged no
charge icon is displayed when the charger
is plugged in. It is displayed after 2 hours
at most. In this case the battery is fully
charged after 3–4 hours.
Only use the charger provided!
Display while in service
Charge level display during operation
(empty-full):
a d g
A beep sounds when the battery is nearly
empty. The charge level of the battery is
displayed correctly only after uninterrupt-
ed charging/discharging. You should not
remove the battery unnecessarily and if pos-
sible not end charging prematurely.
The charger heats up when used for long
periods. This is normal and not dangerous.
Switch on/off, PIN entry
Switch on/off
Press and hold On/Off/End key
B
to
switch on or off.
Enter PIN
The SIM card can be protected with a 4–8
digit PIN.
Enter the PIN code using the number keys
(the display shows a series of asterisks, if
you make a mistake press §Clear§ ).
Confirm your input with §OK§ . Logging on
to the network will take a few seconds.
First time switching on phone, the time
and date must be set (p. 21).
Standby mode
When the name of the service provider/
logo appears on the display, the phone is
in standby mode and ready for use.
Press and hold the On/Off/End key
B
to
return to standby mode from any menu
option.
General information
User Guide
The following symbols are used to explain
operation:
J Enter numbers or letters
B
On/Off/End key
A
Call key
G
Press scroll key at the top/at the
bottom to scroll up and down
<
Soft key left
>
Soft key right
§Menu§ Displays a function
L
Function depends on the service
provider, special registration
may be necessary
Menu Control
Steps for calling a function are shown in
a condensed form in this user guide, e.g. to
display the call list for missed calls:
§Menu§
¢
Call records
¢
Missed calls
This corresponds to:
Open the main menu, select the Call
records menu, then select Missed calls .
You have to confirm with §Select§ .