Minicom Advanced Systems 3000 - Manual (Page 16)

DS VISION 3000
15
Auto-detect
Note! Auto-detection only works if the Service Utility is online. Check the Title
line of the Service Utility window, see Figure 17. When offline, connect to the
system by choosing File/Connect.
To auto-detect the topology, click and when prompted click Yes.
A detected topology appears on the left showing all connected DS Vision units, as
in the following figure.
Figure 18 Auto-detected topology
Note! You can detect the current topology at any time by pressing .
This fully updates all connected and disconnected ports.
Note!
Auto-detect deletes all names given to particular ports. Naming ports is explained
on page 17.
Tip!
Hold the mouse over any of the rows in the menu tree or over any button. A callout
appears with information about the device or button function.
Check
When units have been connected or disconnected since last detecting the topology
you can check for any changes to the topology.