Introduction, At command summary – Multi-Tech Systems MT4X56USB User Manual
Page 40
MultiModemUSB User Guide
MT4X56USB
40
Introduction
The AT commands are used to control the operation of your modem. They are called AT commands
because each command must be preceded by the characters AT to get the ATtention of the modem.
AT commands can be issued only when the modem is in command mode or online command mode.
The modem is in command mode whenever it is not connected to another modem. The modem is in
data mode whenever it is connected to another modem and ready to exchange data. Online
command mode is a temporary state in which you can issue commands to the modem while
connected to another modem. To put the modem into online command mode from data mode, you
must issue an escape sequence (+++) followed immediately by the AT characters and the command
(e.g., +++ATH to hang up the modem). To return to data mode from online command mode, you must
issue the command ATO.
To send AT commands to the modem you must use a communications program, such as the
HyperTerminal application in Windows 95/98 and NT 4.0/200041
, or the communications program included with your modem. You can issue commands to the modem
either directly, by typing them in the terminal window of the communications program, or indirectly, by
configuring the operating system or communications program to send the commands automatically.
Fortunately, communications programs make daily operation of modems effortless by hiding the
commands from the user. Most users, therefore, need to use AT commands only when reconfiguring
the modem, e.g., to turn autoanswer on or off.
The format for entering an AT command is ATXn, where X is the command and n is the specific value
for the command, sometimes called the command parameter. The value n is always a number. If the
value is zero, you can omit it from the command; thus, AT&W is equivalent to AT&W0. Most
commands have a default value, which is the value that is set at the factory. The default values are
shown in the “AT Command Summary,” section below.
You must press ENTER to send the command to the modem. Any time the modem receives a
command, it sends a response known as a result code. The most common result codes are OK,
ERROR, and the CONNECT messages that the modem sends to the computer when it is connecting
to another modem. For a table of valid result codes, see “Result Codes” in this chapter.
You can issue several commands in one line, in what is called a command string. The command
string begins with AT and ends when you press ENTER. Spaces to separate the commands are
optional; they are ignored by the command interpreter. The most familiar command string is the
initialization string, which is used to configure the modem when it is turned on or reset, or when your
communications software calls another modem.
AT Command Summary
Command: AT
Attention Code
Values:
n/a
Description:
The attention code precedes all command lines except A/, A:, and escape
sequences.
Command: ENTER Key
Values:
n/a
Description:
Press the E
NTER
(R
ETURN
) key to execute most commands.
Command: A
Answer
Values:
n/a
Description:
Answer incoming call immediately.
Command: A/
Repeat Last Command
Values:
n/a
Description:
Repeat the last command string. Do not precede this command with AT. Do not
press E
NTER
to execute.