IBM SG24-4817-00 - Manual (Page 79)

This soft copy for use by IBM employees only.
• Perform a memory dump of the ATM TR/Ethernet Bridge Module
To install the Configuration Utility Program, insert the diskette that contains the
program in the diskette drive in your workstation, start Windows, and select Run
from the Program Manager File menu. This procedure starts the execution of
the install.exe file from the diskette, which installs the Configuration Utility
Program. When the installation is complete, the ATM TR/Ethernet Bridge
Module configuration group will appear as an icon on the Program Manager
window (see Figure 26).
Figure 26. ATM TR/Ethernet B r i d g e M o d u l e Configuration Window
To use the Configuration Utility Program to manage the ATM TR/Ethernet Bridge
Module, the workstation running this program must be able to access the ATM
TR/Ethernet Bridge Module either via the service port or through a LAN or ATM
port.
To use the service port, the workstation must be directly attached to the serial
EIA 232 port (labeled service on the ATM TR/Ethernet Bridge Module, see
Figure 27 on page 64) and must use the Serial Line Internet Protocol (SLIP) to
communicate with the ATM TR/Ethernet Bridge Module. Therefore, make sure
that the TCP/IP protocol is running in the workstation, and that SLIP is correctly
set up in the TCP/IP configuration.
Chapter 4. IBM 8285 ATM Modules
63