Intelligent Motion Systems intell-print om-192-s - Manual (Page 11)

11
1. By turning the power on while pressing the SEL button the printer will
print the current configuration and get in SET-UP mode.
2. The power LED will flash every second to indicate the printer is in SET-
UP mode.
3. By pressing the FEED button, in SET-UP mode, you can scroll through
the printer parameters in the order shown in the table below.
4. Pressing the SEL button will cause the setting of a parameter to
change in the sequence shown below.
5. Once the desired setting is selected, it can be saved by pressing the
SEL button while pressing the FEED button.
NOTE: IF NO BUTTONS ARE PRESSED FOR 15 SECONDS, THE SET-UP
MODE IS AUTOMATICALLY TERMINATED WITHOUT CHANGING THE
ORIGINAL PARAMETERS.
PARAMETER (FEED Button) STATUS (SEL Button)
8BIT DATA
NUMBER OF DATA BITS
7BIT DATA
NO PARITY
ODD PARITY
SERIAL PARITY
EVEN PARITY
2400 BAUD
4800 BAUD
9600 BAUD SERIAL BAUD RATE
19200 BAUD
U.S.A.
FRANCE
GERMANY
U.K.
DENMARK I
SWEDEN
ITALY
SPAIN
JAPAN
NORWAY
CHARACTER SET
DENMARK II
TEXT(NORMAL PRINT)
PRINT MODE
DATA(INVERTED PRINT)
5MIN
1MIN
AUTO POWER OFF
DISABLE
STANDARD(DH1000)
CITIZEN 560
EMULATION
ESC/POS
NORMAL
DTR
INVERTED
8.2 Set-up Through the Data Port