Intelligent Motion Systems intell-print om-192-s - Manual (Page 17)

17
REVERSE PRINT CTRL Y 19H 25
DOUBLE HEIGHT CTRL Z 1AH 26
GRAPHICS CTRL [,n 1BH, n 27,n
12.2 COMMAND SUMMARY FOR EPSON ESC/POS EMULATION
FUNCTION KEYSTROKE HEX DECIMAL
HORIZONTAL TAB CTRL I 09H 9
LINE FEED CTRL J 0AH 10
FORM FEED CTRL L 0CH 12
CARRIAGE RETURN CTRL M 0DH 13
SET PRINT MODE ESC ! n 1BH,21H,n 27,33,n
INITIALIZE PRINT ESC @ 1BH,40H 27,64
CHARACTER SET ESC R n 1BH,52H,n 27,82,n
PRINT & FEED ESC d n 1BH,64H,n 27,100,n
STATUS REQUEST ESC v 1BH,76H 27,118
INVERTED PRINTING ESC { n 1BH,7BH,n 27,123,n
SET FORM LENGTH ESC C n 1BH,43H,n 27,67,n
12.3 COMMAND SUMMARY FOR CITIZEN 560 EMULATION
FUNCTION KEYSTROKE HEX DECIMAL
LINE FEED CTRL J 0AH 10
FORM FEED CTRL L 0CH 12
CARRIAGE RETURN CTRL M 0DH 13
REVERSE PRINT CTRL T 14H 20
CLEAR BUFFER CTRL X 18H 24
GRAPHIC PRINT ESC K 1BH,4BH
PAGE LENGTH/FORMAT ESC C 1BH,43H
PAGING IS OFF ESC 0 1BH,4FH
2.75MM SPACING ESC1 1BH,31H
5.5MM SPACING ESC 2 1BH,32H
COMMANDS
ACKNOWLEDGED
BUT NOT
EXECUYED
DOUBLE WIDTH 1EH 30
SINGLE WIDTH 1FH 31
11.2 COMMAND DESCRIPTIONS
11.2.1 COMMAND DESCRIPTION FOR DH1000 EMULATION
TAB(09H) : Moves the print position to the nest horizontal tab position. The default tab positions
are at every 8 character intervals. This command will be ignored unless the nest horizontal tab
position is set.
LINE FEED(0AH) : Prints the data in the print buffer and feeds one line based on the current
line spa cing . IF LF+CR IS SENT, CR WILL BE IGNORED TO AVOID DOUBLE FEEDING.
FORM FEED(0BH) : The printer fast feeds to the top of form set by software. Any character in
the buffer will be printed and the buffer pointer will be reset.
VERTICAL TAB(0CH,N) : Printer feeds the paper by N lines. N is a single byte hex number in
the 0<n<20h range. Note that a vertical tab will print the contents of the line buffer before being
executed.