InStep SS150 - Manual (Page 4)

4
Step 3. Front Wheel Assembly
Turn stroller upright onto its rear wheels, then tip
stroller back so the handlebar is down on the
ground and the front is up. Slide the front wheel
assembly onto the front wheel post, push until the
wheel assembly locks into place (Figure C1).
Check to see that the wheel assembly is properly
inserted by pulling on the wheel firmly. To remove
wheel push on release tab and pull off wheel
(Figure C2).
To lock the front wheel from turning:
Push down on the front wheel’s lock lever to keep
the front wheel from turning. To unlock, lift up on
lever (Figure C3).
Step 4. Front Fender Assembly
While stroller is still upright on its rear wheels, align
the fender’s tabs with the holes in the front frame
and press on. Insert the #4 – 16mm screws into the
hole and tighten with a Phillips screwdriver, repeat
for the other 3 holes (Figure D).
WARNING: To avoid burns, never put hot
liquids in the parent or child tray. To prevent
tipping over do not place more than 2 lbs. or
1 kg on either parent or child tray.
C1
C2
C3 D
Front Wheel
Post
Front Wheel
Release Tab
Front Wheel
Lock Lever
Fender
Tab
Front Wheel
Assembly
Front Frame
Fender Holes