InStep SS150 - Manual (Page 5)

5
Step 5. Installing Child Tray
Position tray as shown with the levers open, when
aligned close both levers to lock in place (Figure E).
To remove open both levers and pull off. Note the
child tray can not be used when using the car seat
adapter bar.
Step 6. Installing Parent’s Convenience
Tray
Snap parent tray onto the handlebar aligning the
tray’s holes with the handlebar’s knobs (Figure F).
Step 7. Adjusting Handle Height
While pushing both handle buttons in, rotate
handle to the desired height (Figure G).
Step 8. Proper use of Seat Belt,
Shoulder Straps, and Recline
WARNING: Avoid serious injury from falling
or sliding out. Always use seat belt.
1. Place child in stroller seat. Make sure T-shield is
between the child’s legs.
2. When child is seated, place shoulder straps over
the child’s shoulders and clip onto the waist ring.
3. Buckle the T-shield buckles into the side waist
buckles. Adjust the waist and shoulder straps
for snug fit (Figure H).
E
F
G H
Child Tray
Levers
Parent Tray Hole
Handle Adjust
Button
Shoulder
Straps
Handlebar Knob
Handle Adjust
Button
Waist
Strap
T-shield