Integra TUN-3.7 - Manual (Page 11)

11
Remote Controller
A Standby/On button (19)
Sets the TUN-3.7 to On or Standby.
B Number buttons (20, 23, 28)
Used to select radio presets by number, and to enter
AM/FM station frequencies and XM Radio channel
numbers in Direct Tuning mode.
C Direct Tuning button (20, 23)
Selects the Direct Tuning mode. With AM and FM,
you can select a station directly by entering its fre-
quency. With XM, you can select a station directly
by entering its channel number.
D Return button (28)
Returns to the previous display.
E Arrow [ ]/[ ]/[ ]/[ ] buttons (12, 22–25, 28)
With AM and FM, the Up and Down [ ]/[ ] but-
tons are used for tuning. With XM Radio, the Up
and Down [ ]/[ ] buttons are used to select chan-
nels.
The Left and Right [ ]/[ ] buttons are used to
select category.
F Preset [+]/[–] buttons (27)
Used to select radio presets.
G Auto Scan button (26, 27)
Starts the Auto Scan function, which selects and
outputs each radio preset in turn for 5 seconds.
H Band button (19, 22)
Used to select radio bands, AM, FM, and so on. The
bands available depends on the type of tuner board
installed.
I Display button (24, 26)
Used to view various information on the display.
J Dimmer button (9)
Adjusts the display brightness.
K Ent and Enter buttons (12, 22–25, 28)
Used to confirm various functions and settings. Also
used to select secondary multicast channels with
HD Radio stations.
L Setup button (12, 22, 24, 28)
Selects Setup mode.
M Tuning/CH [ ]/[ ] buttons (19, 23)
With AM and FM, these buttons are used for tuning.
With XM Radio, they’re used to select stations.
N Tuning Mode button (19, 23)
With AM and FM, this button selects the Auto or
Manual tuning mode. With XM Radio, it selects the
search modes.
* XM Radio/HD Radio reception requires C-HDXM
tuner board.
Remote Controller
1
2
3
4
9
J
L
6
7
8
5
K
M
6 M
N